1060 Syslog Commands
Default Configuration
The default value for
level
is error.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example limits syslog messages sent to the logging file based on the severity level
“warning.”
console(config)#logging file warning
logging on
Use the logging on command in Global Configuration mode to control error messages logging.
This command sends debug or error messages to a logging process, which logs messages to
designated locations asynchronously to the process that generated the messages. To disable the
logging process, use the no form of this command.
Syntax
logging on
no logging on
Default Configuration
Logging is enabled.
Command Mode
Global Configuration mode
User Guidelines
The logging process controls the distribution of logging messages to the various destinations,
such as the logging buffer, logging file, or syslog server. Logging on and off for these destinations
can be individually configured using the logging buffered, logging file, and logging
<server>global configuration commands. However, if the logging on command is disabled, no
messages are sent to these destinations. Only the console receives messages.
To Next Page
Loading...
