Dell PowerConnect 8024 Cli Reference Guide

306 IP Addressing Commands
Cache: TTL (Hours)
Host Total Elapsed Type Addresses
---------------- ----- ------- ------- -------------
www.stanford.edu 72 3 IP 171.64.14.203
show ip helper-address
Use the show ip helper-address command in Privileged EXEC mode to display IP helper
addresses configuration.
Syntax
show ip helper-address [ intf-address ]
• intf-address — IP address of a routing interface. (Range: Any valid IP address)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
console#show ip helper-address
IP helper is enabled
Interface UDP Port Discard Hit Count Server Address
-------------------- ----------- ---------- ---------- ------------------
vlan 25 domain No 0 192.168.40.2
vlan 25 dhcp No 0 192.168.40.2
vlan 30 dhcp Yes 0
vlan 30 162 No 0 192.168.23.1
Any dhcp No 0 192.168.40.1

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries