Dell PowerConnect 8024 - Interface Loopback; Show Interfaces Loopback

Loopback Interface Commands 703
46
Loopback Interface Commands
This chapter explains the following commands:
• interface loopback
• show interfaces loopback
interface loopback
Use the interface loopback command in Global Configuration mode to enter the Interface
Loopback configuration mode.
Syntax
interface loopback loopback-id
no interface loopback loopback-id
• loopback-id — Loopback identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enters the Interface Loopback 1 configuration mode.
console(config)# interface loopback 1
console(config-if-loopback1)#
show interfaces loopback
Use the show interfaces loopback command in Privileged EXEC mode to display information
about one or all configured loopback interfaces.