Dell PowerConnect 8024 - Iscsi Aging Time

iSCSI Flow Acceleration Commands 329
21
iSCSI Flow Acceleration Commands
This chapter explains the following commands:
• iscsi aging time
• iscsi cos
• iscsi enable
• iscsi target port
•show iscsi
• show iscsi sessions
iscsi aging time
The iscsi aging time command sets the time out value for iSCSI sessions. To reset the aging
time to the default value, use the no form of this command.
Syntax
iscsi aging time time
no iscsi aging time
• time — The number of minutes a session must not be active prior to it's removal. (Range: 1
43,200)
Default Configuration
10 minutes.
Command Mode
Global Configuration mode.
User Guidelines
Changing the aging time has the following behavior:
• When aging time is increased, current sessions will be timed out according to the new value.
• When aging time is decreased, any sessions that have been dormant for a time exceeding the
new setting will be immediately deleted from the table. All other sessions will continue to be
monitored against the new time out value.