IPv6 Routing Commands 687
Version........................................ 3
Num of Multicast Groups........................ 0
Unsolicited Report Interval.................... 1
Querier IP Address on Proxy Interface.......... fe80::1:2:5
Older Version 1 Querier Timeout................ 00:00:00
Proxy Start Frequency...........................1
show ipv6 mld-proxy groups
Use the show ipv6 mld-proxy groups command to display information about multicast groups
that the MLD Proxy reported.
Syntax
show ipv6 mld-proxy groups
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC
User Guidelines
The following parameters are displayed by this command:
Interface The MLD Proxy interface.
Group Address The IP address of the multicast group.
Last Reporter The IP address of the host that last sent a membership report for the current group
on the network attached to the MLD-Proxy interface (upstream interface).
Up Time (in secs) The time elapsed in seconds since last created.
Member State Possible values are:
• Idle_Member—The interface has responded to the latest group membership query
for this group.
• Delay_Member—The interface is going to send a group membership report to
respond to a group membership query for this group.
Filter Mode Possible values are Include or Exclude.
Sources The number of sources attached to the multicast group.
To Next Page
Loading...
