Dell PowerConnect 8024 - Tunnel Mode Ipv6 Ip

Tunnel Interface Commands 861
no tunnel destination
• ipv4addr — Valid ipv4 address.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Tunnel) mode.
User Guidelines
This command has no user guidelines.
Example
The following example specifies the destination transport address of tunnel 1.
console(config)#interface tunnel 1
console(config-if-tunnel1)#tunnel destination 10.1.1.1
tunnel mode ipv6ip
Use the tunnel mode ipv6ip command in Interface Configuration mode to specify the mode of
the tunnel.
Syntax
tunnel mode ipv6ip [6to4]
no tunnel mode
• 6to4 — Sets the tunnel mode to automatic.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Tunnel) mode.
User Guidelines
This command has no user guidelines.
Example
The following example specifies ipv6ip mode for tunnel 1.