Dell PowerConnect 8024 - Group

Captive Portal Commands 889
no enable
Default Configuration
Configurations are enabled by default
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP 2)#no enable
group
Use the group command to configure the group number for a captive portal configuration. If a
group number is configured, the user entry (Local or RADIUS) must be configured with the
same name and the group to authenticate to this captive portal instance. Use the “no” form of
this command to reset the group number to the default.
Syntax
group group-number
no group
• group-number —The number of the group to associate with this configuration (Range: 1–10).
Default Configuration
The default group number is 1.
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP 2)#group 2