OSPFv3 Commands 823
Designated Router........................ 1.1.1.1
Backup Designated Router................. 2.2.2.2
Number of Link Events.................... 46
show ipv6 ospf neighbor
Use the show ipv6 ospf neighbor command in Privileged EXEC mode to display information
about OSPF neighbors. If a neighbor IP address is not specified, the output displays summary
information in a table. If an interface or tunnel is specified, only the information for that
interface or tunnel displays. The information below only displays if OSPF is enabled and the
interface has a neighbor.
Syntax
show ipv6 ospf neighbor [ interface { vlan
vlan-id
| tunnel
tunnel-id
} ] [
ip-address
]
•
vlan-id
— Valid VLAN ID.
•
tunnel-id
— Tunnel identifier. (Range: 0-7)
•
ip-address
— Is the valid IP address of the neighbor about which information is displayed.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Examples
The following examples display information about OSPF neighbors, in the first case in a
summary table, and in the second in a table specific to tunnel 1.
console#show ipv6 ospf neighbor
Router ID Priority Intf Interface State Dead
ID Time
--------- -------- ---- ----------- ------------- ----
console#show ipv6 ospf neighbor interface tunnel 1
To Next Page
Loading...
