Dell PowerConnect 8024 - Show Ipv6 Ospf; Router-ID

810 OSPFv3 Commands
User Guidelines
This command has no user guidelines.
Example
The following example configures the OSPFv3 protocol to allow redistribution of routes from
the specified source protocol/routers.
console(config)#ipv6 router ospf
console(config-rtr)#redistribute connected
router-id
Use the router-id command in Router OSPFv3 Configuration mode to set a 4-digit dotted-
decimal number uniquely identifying the Router OSPF ID.
Syntax
router-id router-id
• router-id — Router OSPF identifier. (Range: 0-4294967295)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets a 4-digit dotted-decimal number identifying the Router OSPF ID as
2.3.4.5.
console(config)#ipv6 router ospf
console(config-rtr)#router-id 2.3.4.5
show ipv6 ospf
Use the show ipv6 ospf command in Privileged EXEC mode to display information relevant to
the OSPF router.