Dell PowerConnect 8024 - Dos-Control L4 Port; Dos-Control Sipdip

Denial of Service Commands 945
dos-control l4port
Use the dos-control l4port command in Global Configuration mode to enable L4 Port Denial of
Service protection. If the mode is enabled, Denial of Service prevention is active for this type of
attack. If packets ingress having Source TCP/UDP Port Number equal to Destination TCP/UDP
Port Number, the packets are dropped.
Syntax
dos-control l4port
no dos-control l4port
Default Configuration
Denial of Service is disabled.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example activates L4 Port Denial of Service protection.
console(config)#dos-control l4port
dos-control sipdip
Use the dos-control sipdip command in Global Configuration mode to enable Source IP
Address = Destination IP Address (SIP=DIP) Denial of Service protection. If the mode is
enabled, Denial of Service prevention is active for this type of attack. If packets ingress with
SIP=DIP, the packets is dropped if the mode is enabled.
Syntax
dos-control sipdip
no dos-control sipdip
Default Configuration
Denial of Service is disabled.