494 VLAN Commands
Command Mode
Global Configuration mode
User Guidelines
Commands used in the interface range context are executed independently on each interface in
the range. If the command returns an error on one of the interfaces, an error message is
displayed and execution continues on other interfaces.
Example
The following example groups VLAN 221 till 228 and VLAN 889 to receive the same command.
console(config)#interface range vlan 221-228,889
console(config-if)#
mode dvlan-tunnel
Use the mode dvlan-tunnel command in Interface Configuration mode to enable Double
VLAN Tunneling on the specified interface. To disable Double VLAN Tunneling on the
specified interface, use the no form of this command.
Syntax
mode dvlan-tunnel
no mode dvlan-tunnel
Default Configuration
By default, Double VLAN Tunneling is
disabled
.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to enable Double VLAN Tunneling at ethernet port 1/g1.
console(config-if-1/g1)#mode dvlan-tunnel
To Next Page
Loading...
