IPv6 MLD Snooping Querier Commands 321
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 mld snooping querier timer expiry 222
show ipv6 mld snooping querier
Use the show ipv6 mld snooping querier command to display MLD Snooping Querier
information. Configured information is displayed whether or not MLD Snooping Querier is
enabled.
Syntax
show ipv6 mld snooping querier [ detail | vlan
vlan-id
]
•
vlan-id
— A valid VLAN ID. (Range: 1 - 4093)
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
When the optional argument vlan vlan-id is not used, the command shows the following
information:
MLD Snooping Querier Mode Indicates whether or not MLD Snooping Querier is active on the
switch.
Querier Address Shows the IP Address which will be used in the IPv6 header while
sending out MLD queries.
MLD Version Indicates the version of MLD that will be used while sending out the
queries. This is defaulted to MLD v1 and it can not be changed.
Querier Query Interval Shows the amount of time that a Snooping Querier waits before
sending out a periodic general query.
Querier Expiry Interval Displays the amount of time to wait in the Non-Querier operational
state before moving to a Querier state.
To Next Page
Loading...
