Dell PowerConnect 8024 - Ip Igmp-Proxy

IGMP Proxy Commands 599
40
IGMP Proxy Commands
This chapter explains the following commands:
•ip igmp-proxy
•ip igmp-proxy reset-status
• ip igmp-proxy unsolicited-report-interval
• show ip igmp-proxy
• show ip igmp-proxy interface
• show ip igmp-proxy groups
• show ip igmp-proxy groups detail
ip igmp-proxy
Use the ip igmp-proxy command in Interface Configuration mode to enable the IGMP Proxy
on the router. To enable the IGMP Proxy on the router, multicast forwarding must be enabled
and there must be no multicast routing protocols enabled on the router.
Syntax
ip igmp-proxy
no ip igmp-proxy
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example enables the IGMP Proxy on the VLAN 15 router.
console(config)#interface vlan 15