Dell PowerConnect 8024 Cli Reference Guide

Multicast Commands 725
Join Prune Interval (secs)..................... 60
Neighbor Count ................................ 0
Designated Router.............................. 1.1.1.1
DR Priority.................................... 1
BSR Border..................................... Disabled
show ip pimsm rphash
The show ip pimsm rphash command displays which rendezvous point (RP) is being selected
for a specified group.
Syntax
show ip pimsm rphash group-address
• group-address — Group IP address supported by RP.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
The following fields are displayed:
RPAddress of the RP for the group specified
OriginIndicate by which mechanism (BSR or static) the RP was selected.
Example
console#show ip pimsm rphash 225.1.0.5
RP Type
Address
---------------- -----
1.1.1.1 Static

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries