Dell PowerConnect 8024 - Datacenter-Bridging; Priority-Flow-Control Mode on

202 Data Center Bridging Commands
datacenter-bridging
Use the datacenter-bridging command for an ethernet or port-channel interface in order to
enter the DataCenterBridging mode. Priority-Flow-Control is configurable from within the
DataCenterBridging mode.
Syntax
datacenter-bridging
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
User Guidelines
This command has no user guidelines.
Example
console#config
console(config)#interface range ethernet all
console(config-if)#datacenter-bridging
console(config-if-dcb)#priority-flow-control mode on
console(config-if-dcb)#priority-flow-control priority 1 no-drop
priority-flow-control mode on
Use the priority-flow-control mode on command in Datacenter-Bridging mode to enable
Priority-Flow-Control (PFC) on an interface. To disable Priority-Flow-Control, use the no form
of the command.
Syntax
priority-flow-control mode on
no priority-flow-control mode
Default Configuration
Priority-flow-control mode is disabled by default.