Dell PowerConnect 8024 - Show Ipv6 Ospf Interface

818 OSPFv3 Commands
console#show ipv6 ospf database database-summary
OSPF Router with ID (0.0.0.2)
Router database summary
Router......................................... 0
Network........................................ 0
Inter-area Prefix.............................. 0
Inter-area Router.............................. 0
Type-7 Ext..................................... 0
Link........................................... 0
Intra-area Prefix.............................. 0
Link Unknown................................... 0
Area Unknown................................... 0
AS Unknown..................................... 0
Type-5 Ext..................................... 0
Self-Originated Type-5 Ext..................... 0
Total.......................................... 0
show ipv6 ospf interface
Use the show ipv6 ospf interface command in Privileged EXEC mode to display the
information for the IFO object or virtual interface tables.
Syntax
show ipv6 ospf interface {vlan vlan-id | tunnel tunnel-id | loopback loopback-id }
• vlan-id — Valid VLAN ID.
•
tunnel-id — Tunnel identifier. (Range: 0-7)
•
loopback-id — Loopback identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode