Dell PowerConnect 8024 Cli Reference Guide

Serviceability Tracing Packet Commands 1005
Example
console#debug ospfv3 packet
debug ping
Use the debug ping command to enable tracing of ICMP echo requests and responses. This
command traces pings on the network port and on the routing interfaces. Use the “no” form of
this command to disable tracing of ICMP echo requests and responses.
Syntax
debug ping packet
no debug ping packet
Default Configuration
Display of ICMP echo traces is disabled by default.
Command Mode
Privileged EXEC mode.
Usage Guidelines
There are no usage guidelines for this command.
Example
The following example displays.
console#debug ping packet
debug rip
Use the debug rip command to enable tracing of RIP requests and responses. Use the “no” form
of this command to disable tracing of RIP requests and responses.
Syntax
debug rip packet
no debug rip packet
Default Configuration
Display of RIP traces is disabled by default.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries