Dell PowerConnect 8024 Cli Reference Guide

596 IGMP Commands
Query Interval (secs).......................... 125
Query Max Response Time (1/10 of a second)..... 100
Robustness..................................... 2
Startup Query Interval (secs) ................. 31
Startup Query Count............................ 2
Last Member Query Interval (1/10 of a second).. 10
Last Member Query Count........................ 2
show ip igmp interface membership
Use the show ip igmp interface membership command in Privileged EXEC mode to display the
list of interfaces that have registered in the multicast group. If detail is specified, this command
displays detailed information about the listed interfaces.
Syntax
show ip igmp interface membership groupaddr [detail]
• groupaddr — Group IP address
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Examples
The following examples display the list of interfaces that have registered in the multicast group
at IP address 224.5.5.5, the latter in detail mode.
console#show ip igmp interface membership 224.5.5.5
IGMP INTERFACE MEMBERSHIP INFO
Interface Interface IP State Group Compat Source Filter
Mode Mode
--------- --------------- ------------ ------------ -------------

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries