Dell PowerConnect 8024 - External-Lsdb-Limit

OSPFv3 Commands 799
no exit-overflow-interval
• seconds — Exit overflow interval for OSPF (Range: 0-2147483647)
Default Configuration
0 is the default value for seconds .
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the exit overflow interval for OSPF at 100 seconds.
console(config)#ipv6 router ospf
console(config-rtr)#exit-overflow-interval 100
external-lsdb-limit
Use the external-lsdb-limit command in Router OSPFv3 Configuration mode to configure the
external LSDB limit for OSPF. If the value is -1, then there is no limit. When the number of
non-default AS-external-LSAs in a router's link-state database reaches the external LSDB limit,
the router enters overflow state. The router never holds more than the external LSDB limit non-
default ASexternal- LSAs in it database. The external LSDB limit MUST be set identically in all
routers attached to the OSPF backbone and/or any regular OSPF area.
Syntax
external-lsdb-limit limit
no external-lsdb-limit
• limit — External LSDB limit for OSPF (Range: -1-2147483647)
Default Configuration
-1 is the default value for limit .
Command Mode
Router OSPFv3 Configuration mode.