Dell PowerConnect 8024 Cli Reference Guide

242 Ethernet Configuration Commands
Example
console(config-if-1/xg17)#negotiation 1000f 10000f
show interfaces advertise
Use the show interfaces advertise command in Privileged EXEC mode to display information
about auto-negotiation advertisement.
Syntax
show interfaces advertise [ethernet interface ]
• interface — A valid Ethernet port.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following examples display information about auto negotiation advertisement.
console#show interfaces advertise
Port Type Neg Operational Link Advertisement
---- ---- --- ------------------------------
1/g2 1G-Copper Enable 1000f, 100f, 100h, 10f, 10h
1/g2 1G-Copper Enable 1000f
console# show interfaces advertise ethernet 1/g1
Port: Ethernet 1/g1
Type: 1G-Copper
Link state: Up
Auto negotiation: enabled
10h 10f 100h 100f 1000f

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries