Dell PowerConnect 8024 Cli Reference Guide

1092 System Management Commands
show switch chassis-mgmt
Use the show switch chassis-mgmt command in Priv EXEC mode to show the chassis slot of the
IOMs in a stack.
Syntax
show switch chassis-mgmt
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
It is possible for two IOMs in a stack to have the same slot ID if they are in different chassis.
Example
console#show switch chassis-mgmt
Management
Switch Status Slot
------ ------------ -------
2 Mgmt Switch A1
4 Stack Member B1
console#
Plugged-In Model Identifier This field displays the model identifier of the switch in the
stack. Model Identifier is a 32-character field assigned by
the switch manufacturer to identify the switch.
Switch Status This field indicates the switch status. Possible values for
this state are: OK, Unsupported, CodeMismatch,
ConfigMismatch, or NotPresent.
Code Version This field indicates the detected version of code on this
switch.
Unit Description

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries