Dell PowerConnect 8024 - Show Ipv6 Mld Snooping

638 IPv6 MLD Snooping Commands
User Guidelines
There are no user guidelines for this command.
Example
console(config-vlan)#ipv6 mld snooping 1
show ipv6 mld snooping
The show ipv6 mld snooping command displays MLD Snooping information. Configured
information is displayed whether or not MLD Snooping is enabled.
Syntax
show ipv6 mld snooping [interface {ethernet interface | port-channel port-channel-number } |
vlan
vlan-id ]
Default Configuration
This command has no default configuration
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Example
With no optional arguments, the command displays the following information:
• Admin Mode — Indicates whether or not MLD Snooping is active on the switch.
• Interfaces Enabled for MLD Snooping — Interfaces on which MLD Snooping is enabled.
• MLD Control Frame Count — This displays the number of MLD control frames that are
processed by the CPU.
• VLANs Enabled for MLD Snooping — VLANs on which MLD Snooping is enabled.
When you specify an interface or VLAN, the following information displays:
• MLD Snooping Admin Mode — Indicates whether MLD Snooping is active on the interface
or VLAN.
• Fast Leave Mode — Indicates whether MLD Snooping Fast-leave is active on the VLAN.
• Group Membership Interval — Shows the amount of time in seconds that a switch will wait
for a report from a particular group on a particular interface, which is participating in the
VLAN, before deleting the interface from the entry. This value may be configured.