IPv6 Routing Commands 701
show ipv6 vlan
Use the show ipv6 vlan command in Privileged EXEC mode to display IPv6 VLAN routing
interface addresses.
Syntax
show ipv6 vlan
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays IPv6 VLAN routing interface addresses.
console#show ipv6 vlan
MAC Address used by Routing VLANs: 00:02:BC:00:30:68
VLAN ID IPv6 Address/Prefix Length
------- ---------------------------------------
1
traceroute ipv6
Use the traceroute ipv6 command in Privileged EXEC mode to discover the routes that packets
actually take when traveling to their destination through the network on a hop-by-hop basis.
Syntax
traceroute ipv6 {
ip-address
|
hostname
}
[
port
]
•
ipv6-address
— Destination IPv6 address.
•
hostname
— Hostname to ping (contact). (Range: 1–158 characters)
•
port
— UDP port used as the destination of packets sent as part of the traceroute. This port
should be an unused port on the destination system. (Range: 0–65535)
To Next Page
Loading...
