Dell PowerConnect 8024 - Show Switchport Voice

Auto-VoIP Commands 185
7
Auto-VoIP Commands
This chapter explains the following commands:
• show switchport voice
• switchport voice detect auto
show switchport voice
Use the show switchport voice command to show the status of Auto-VoIP on an interface or all
interfaces.
Syntax
show switchport voice [interface {ethernet interface | port-channel index }]
• ethernet interface —Specifies a valid interface. The full syntax is unit/port.
•
port-channel index — Specifies the port-channel number.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
console#show switchport voice
Interface Auto VoIP Mode Traffic Class
--------- -------------- -------------
1/g1 Enabled 6
1/g2 Enabled 6