Dell PowerConnect 8024 - Show Ip Irdp

Router Discovery Protocol Commands 843
• integer — Preference of the address as a default router address, relative to other router
addresses on the same subnet. (Range: -2147483648 to 2147483647
)
Default Configuration
0 is the default value.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the ip irdp preference to 1000 for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ip irdp preference 1000
show ip irdp
Use the show ip irdp command in Privileged EXEC mode to display the router discovery
information for all interfaces, or for a specified interface.
Syntax
show ip irdp {vlan vlan-id |all}
• vlan-id — Valid VLAN ID
•
all — Shows information for all interfaces.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Example
The following example shows router discovery information for VLAN 15.