Dell PowerConnect 8024 - Default-Metric

796 OSPFv3 Commands
Syntax
default-information originate [always] [metric integer ] [metric-type {1 | 2}]
no default-information originate [metric] [metric-type]
• always — Always advertise default routes.
•
integer — The metric (or preference) value of the default route. (Range: 1–16777214)
• 1—External type-1 route.
• 2—External type-2 route.
•
metric — Specify the metric of the default route.
•
metric-type — Specify metric-type of the default route.
Default Configuration
2 is the default value for metric-type.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example controls the advertisement of default routes by defining a metric value
of 100 and metric type 2.
console(config)#ipv6 router ospf
console(config-rtr)#default-information originate metric 100
metric-type 2
default-metric
Use the default-metric command in Router OSPFv3 Configuration mode to set a default for
the metric of distributed routes.
Syntax
default-metric metric
no default-metric
• metric — Metric value used for distribution (Range: 1-16777214)