Dell PowerConnect 8024 - Spanning-Tree Max-Age

Spanning Tree Commands 473
Syntax
spanning-tree loopguard default
no spanning-tree loopguard default
Default Configuration
Loop guard is disabled by default.
Command Mode
Global Configuration mode
Usage Guidelines
There are no usage guidelines for this command.
Example
The following example enables spanning-tree loopguard functionality on all ports.
console(config)#spanning-tree loopguard default
spanning-tree max-age
Use the spanning-tree max-age command in Global Configuration mode to configure the
spanning-tree bridge maximum age. To reset the default maximum age, use the no form of this
command.
Syntax
spanning-tree max-age seconds
no spanning-tree max-age
• seconds -Time in seconds. (Range: 6–40)
Default Configuration
The default max-age for IEEE STP is 20 seconds.
Command Mode
Global Configuration mode
User Guidelines
When configuring the Max-Age the following relationships should be satisfied:
2*(Forward-Time - 1) >= Max-Age