890 Captive Portal Commands
interface
Use the interface command to associate an interface with a captive portal configuration. Use
the “no” form of this command to remove an association.
Syntax
interface
interface
no interface
interface
interface
—An interface or range of interfaces.
Default Configuration
No interfaces are associated with a configuration by default.
Command Mode
Captive Portal Instance Config mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP 2)#interface 1/g2
locale
The locale command is not intended to be a user command. The administrator must use the
WEB UI to create and customize captive portal web content. This command is primarily used
by the show running-config command and process as it provides the ability to save and restore
configurations using a text based format.
Syntax
locale
web-id
•
web-id
—The locale number (Range: Only locale 1 is supported)
Default Configuration
Locale 1 is configured by default.
Command Mode
Captive Portal Instance mode.
To Next Page
Loading...
