Dell PowerConnect 8024 Cli Reference Guide

Multicast Commands 721
console#show ip mcast mroute group 224.5.5.5 detail
Multicast Route Table
Expiry Up Time
Source Ip Group Ip Time(secs) (secs) RPF Neighbor Flags
--------- --------- ----------- --------- --------------- -----
show ip mcast mroute source
Use the show ip mcast mroute source command in Privileged EXEC mode to display the
multicast configuration settings such as flags, timer settings, incoming and outgoing interfaces,
RPF neighboring routers, and expiration times of all the entries in the multicast mroute table
containing the
sourceipaddr or sourceipaddr | groupipaddr pair value(s).
Syntax
show ip mcast mroute source sourceipaddr {summary | groupipaddr }
• sourceipaddr — IP address of source.
•
groupipaddr — IP address of multicast group.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Example
The following example displays multicast configuration settings.
console#show ip mcast mroute source 10.1.1.1 summary
Multicast Route Table Summary
Incoming Outgoing
Source IP Group IP Protocol Interface Interface List
---------- --------------- --------- --------- ----------------

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries