Dell PowerConnect 8024 - Show Ipv6 Pimdm Interface

694 IPv6 Routing Commands
show ipv6 pimdm interface
The show ipv6 pimdm interface command is used to display PIM-DM Configuration
information for all interfaces or for the specified interface. If no interface is specified,
Configuration of all interfaces is displayed.
Syntax
show ipv6 pimdm interface [ vlan vlan-id | all ]
• vlan vlan-id — A valid VLAN ID.
•
all — To show configuration information for all valid interfaces.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
console#show ipv6 pimdm interface vlan 10
Slot/Port...................................... vlan 10
IP Address.....................................
FE80::221:9BFF:FEC3:1216/128
Neighbor Count ................................ 0
Hello Interval (secs).......................... 30
Designated Router.............................. Not Supported
console#show ipv6 pimdm interface all
Address Interface Neighbor Hello
Count Interval
-------------- --------- -------- -------
192.168.37.6 vlan 10 2 30