Dell PowerConnect 8024 - Area Nssa Translator-Stab-Intv; Area Range

OSPFv3 Commands 789
Example
The following example configures the always translator role of the area 1 NSSA.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 nssa translator-role always
area nssa translator-stab-intv
Use the area nssa translator-stab-intv command in Router OSPFv3 Configuration mode to
configure the translator stability interval of the NSSA. The stability interval is the period of time
that an elected translator continues to perform its duties after it determines that its translator
status has been deposed by another router.
Syntax
area areaid nssa translator-stab-intv seconds
no area areaid nssa translator-stab-intv
• areaid — Valid OSPF area identifier.
•
seconds — Translator stability interval of the NSSA. (Range: 0-3600 seconds)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a translator stability interval of 100 seconds for the area 1
NSSA.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 nssa translator-stab-intv 100
area range
Use the area range command in Router OSPF Configuration mode to configure a summary
prefix for routes learned in a given area. There are two types of area ranges. An area range can be
configured to summarize intra-area routes. An ABR advertises the range rather than the specific