IPv6 Multicast Commands 647
Default Configuration
There are no static RP addresses configured by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pimsm rp-address 2001::1 ff1e::/64
ipv6 pimsm rp-candidate
Use the ipv6 pimsm rp-candidate command to configure the router to advertise itself as a PIM
candidate rendezvous point (RP) to the bootstrap router (BSR). Use the "no" form of this
command to disable the router from advertising itself as a PIM candidate rendezvous point (RP)
to the bootstrap router (BSR).
Syntax
ipv6 pimsm rp-candidate vlan
vlan-id group-address/prefixlength
no ipv6 pimsm rp-candidate vlan
vlan-id
• vlan-id—A valid VLAN ID value.
• group-address—The group address to display.
• prefixlength—This parameter specifies the prefix length of the IP address for the media
gateway. (Range: 1–32)
Default Configuration
The router does not advertise itself as a PIM candidate rendezvous point by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pimsm rp-candidate vlan 6 ff1e::/64
To Next Page
Loading...
