Dell PowerConnect 8024 - Member

System Management Commands 1073
console#show interfaces configuration ethernet 1/xg1
Port Type Duplex Speed Neg MDIX Admin Mode
----- ------------ ------- ------- ---- ---- ----------
1/xg1 10G - Level N/A Unknown Auto Auto low-power
member
Use the member command in Stack Global Configuration mode to configure the switch.
Execute this command on the Management Switch. To remove a switch from the stack, use the
no form of the command.
NOTE: The “no” form of the command may not be used if the member is present in the stack.
Syntax
member unit switchindex
no member unit
• unit — The switch identifier of the switch to be added or removed from the stack. (Range:
1–12)
•
switchindex — The index into the database of the supported switch types, indicating the type
of the switch being preconfigured. The switch index is a 32-bit integer.
Default configuration
This command has no defaults.
Command Mode
Stack Global Configuration
User Guidelines
The switch index can be obtained by executing the show supported switchtype command in
User Exec mode.
Example
The following example displays how to add to stack switch number 2 with index 1.
console(config)# stack
console(config-stack)# member 2 1