558 ARP Commands
console(config-if-vlan15)#ip proxy-arp
show arp
Use the show arp command in Privileged EXEC mode to display the Address Resolution
Protocol (ARP) cache. The displayed results are not the total ARP entries. To view the total ARP
entries, the operator should view the show ARP results in conjunction with the show ARP switch
results.
Syntax
show arp [brief] [switch]
• brief — Display ARP parameters and cache.
•switch — Display ARP cache for the switch.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example shows show arp command output.
console#show arp
Age Time (seconds)............................. 1200
Response Time (seconds)........................ 1
Retries........................................ 4
Cache Size..................................... 896
Dynamic Renew Mode ............................ Enable
Total Entry Count Current / Peak .............. 1 / 1
Static Entry Count Configured / Active / Max .. 0 / 0 / 64
console#show arp switch
To Next Page
Loading...
