Dell PowerConnect 8024 Cli Reference Guide

Line Commands 957
Telnet configuration:
Interactive timeout: 10 minutes 10 seconds
History: 10
SSH configuration:
Interactive timeout: 10 minutes 10 seconds
History: 10
speed
Use the speed command in Line Configuration mode to set the line baud rate. Use the no form
of the command to restore the default settings.
Syntax
speed { bps }
no speed
• bps — Baud rate in bits per second (bps). The options are 2400, 9600, 19200, 38400, 57600,
and 115200.
Default Configuration
This default speed is 9600.
Command Mode
Line Interface (console) mode
User Guidelines
This configuration applies only to the current session.
Example
The following example configures the console baud rate to 9600.
console(config-line)#speed 9600

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries