Dell PowerConnect 8024 - Clock Timezone Hours-Offset

920 Clock Commands
Default Configuration
The SNTP Unicast client is disabled.
Command Mode
Global Configuration mode
User Guidelines
Use the sntp server command to define SNTP servers.
Examples
The following example enables the device to use Simple Network Time Protocol (SNTP) to
request and accept SNTP traffic from servers.
console(config)# sntp unicast client enable
clock timezone hours-offset
Use the clock timezone [ hours-offset ] [minutes minutes-offset ] [zone acronym ] command to
set the offset to Coordinated Universal Time (UTC). If the optional parameters are not
specified, they will be read as either '0' or '\0, as appropriate.
Syntax
clock timezone hours-offset [minutes minutes-offset ] [zone acronym ]
• hours-offset — Hours difference from UTC. (Range: –12 to +13)
•
minutes-offset — Minutes difference from UTC. (Range: 0–59)
•
acronym — The acronym for the time zone. (Range: Up to four characters)
Command Mode
Global Configuration
Default Value
No default setting
User Guidelines
No specific guidelines
Example
console(config)#clock timezone -5 minutes 30 zone IST