Dell PowerConnect 8024 - Class

QoS Commands 389
Default Configuration
This command has no default configuration.
Command Mode
Policy-Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to change the queue ID to 4 for the associated traffic
stream.
console(config-policy-classmap)#assign-queue 4
class
Use the class command in Policy-Map Class Configuration mode to create an instance of a class
definition within the specified policy for the purpose of defining treatment of the traffic class
through subsequent policy attribute statements.
Syntax
class classname
no class
• classname — Specifies the name of an existing DiffServ class. (Range: 1–31 characters)
Default Configuration
This command has no default configuration.
Command Mode
Policy Map Configuration mode
User Guidelines
This command causes the specified policy to create a reference to the class definition. The
command mode is changed to Policy-Class-Map Configuration when this command is executed
successfully.
Example
The following example shows how to specify the DiffServ class name of “DELL.”