Dell PowerConnect 8024 Cli Reference Guide

908 Captive Portal Commands
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
console#show trapflags captive-portal
Client Authentication Failure Traps............ Disable
Client Connection Traps........................ Disable
Client Database Full Traps..................... Disable
Client Disconnection Traps..................... Disable
Captive Portal User Group Commands
user group
Use the user group command to create a user group. Use the “no” form of this command to
delete a user group. The default user group (1) cannot be deleted.
Syntax
user group group-id
no user group group-id
group-id
— Group ID (Range: 1–10).
Default Configuration
User group 1 is created by default and cannot be deleted.
Command Mode
Captive Portal Configuration mode.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries