Dell PowerConnect 8024 - Show Ipv6 Dhcp Interface

574 DHCPv6 Commands
Example
The following example displays the configured DHCP pool based on the entered IPv6 address.
console#show ipv6 dhcp binding 2020:1::
show ipv6 dhcp interface
Use the show ipv6 dhcp interface command in User EXEC mode to display DHCPv6
information for all relevant interfaces or a specified interface. If an interface is specified, the
optional statistics parameter is available to view statistics for the specified interface.
Syntax
show ipv6 dhcp interface {tunnel tunnel-id | vlan vlan-id } [statistics ]
• tunnel-id — Tunnel identifier. (Range: 0–7)
•
vlan-id — Valid VLAN ID.
•
statistics — Enables statistics display if interface is specified.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
This command has no user guidelines.
Examples
The following examples display DHCPv6 information for VLAN 11.
console> show ipv6 dhcp interface vlan 11
IPv6 Interface................................. vlan11
Mode........................................... Relay
Relay Address.................................. 2020:1::1
Relay Interface Number......................... Relay
Relay Remote ID................................
Option Flags...................................