Dell PowerConnect 8024 Cli Reference Guide

Captive Portal Commands 907
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
console#show captive-portal configuration status
CP ID CP Name Mode Protocol Verification
----- --------------- -------- -------- ------------
1 cp1 Enable https Guest
2 cp2 Enable http Local
3 cp3 Disable https Guest
console#show captive-portal configuration 1 status
CP ID.......................................... 1
CP Name........................................ cp1
Mode........................................... Enabled
Protocol Mode.................................. https
Verification Mode.............................. Guest
Group Name..................................... group123
Redirect URL Mode.............................. Enabled
Redirect URL................................... www.cnn.com
Session Timeout (seconds)...................... 86400
show trapflags captive-portal
Use the show trapflags captive-portal command to display which captive portal traps are
enabled.
Syntax
show trapflags captive-portal

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries