Dell PowerConnect 8024 - Spanning-Tree Port-Priority; Spanning-Tree Priority

Spanning Tree Commands 481
Usage Guidelines
There are no usage guidelines for this command.
Example
The following example enables Portfast mode on all ports.
console(config)#spanning-tree portfast default
spanning-tree port-priority
Use the spanning-tree port-priority command in Interface Configuration mode to configure
port priority. To reset the default port priority, use the no form of this command.
Syntax
spanning-tree port-priority priority
no spanning-tree port-priority
• priority — The port priority. (Range: 0–240)
Default Configuration
The default port-priority for IEEE STP is 128.
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode
User Guidelines
The priority value must be a multiple of 16.
Example
The following example configures the spanning priority on 1/g5 to 96.
console(config)#interface ethernet 1/g5
console(config-if-1/g5)#spanning-tree port-priority 96
spanning-tree priority
Use the spanning-tree priority command in Global Configuration mode to configure the
spanning-tree priority. The priority value is used to determine which bridge is elected as the root
bridge. To reset the default spanning-tree priority use the no form of this command.