Dell PowerConnect 8024 Cli Reference Guide

250 Ethernet Configuration Commands
Command Mode
User EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the description for the interface 1/g1.
console>show interfaces description
Port Description
---- -----------------------------------------------------------
1/g1 Port that should be used for management only
2/g1
2/g2
Ch Description
---- -----------
1 Output
show interfaces detail
Use the show interfaces detail command in User EXEC mode to display, in a single command,
VLAN information, STP information, and port status information. This command combines
the output of the following commands:
• show interfaces configuration [ethernet interface | port-channel port-channel-number ]
• show interfaces description [ethernet interface | port-channel port-channel-number ]
• show interfaces status [ethernet interface | port-channel port-channel-number ]
• show interfaces switchport {ethernet interface | port-channel port-channel-number }
• show spanning-tree [ ethernet interface-number | port-channel port-channel-number
][instance instance-id ]
Syntax
show interfaces detail {ethernet interface | port-channel port-channel-number }
• interface — A valid Ethernet port.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries