Dell PowerConnect 8024 - Interface Ethernet

238 Ethernet Configuration Commands
Syntax
flowcontrol
no flowcontrol
Default Configuration
Flow Control is enabled.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
In the following example, flow control is enabled.
console(config)# flowcontrol
interface ethernet
Use the interface ethernet command in Global Configuration mode to enter the interface
configuration mode to configure an Ethernet type interface.
Syntax
interface ethernet interface
• interface — Valid Ethernet port. The full syntax is unit/port.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example enables port 5/g18 for configuration.
console(config)# interface ethernet 5/g18