Dell PowerConnect 8024 - Ip Pim-Trapflags; Ip Pimsm Spt-Threshold

834 PIM-SM Commands
ip pimsm spt-threshold
Use the ip pimsm spt-threshold command in Global Configuration mode to configure the Data
Threshold rate for the last-hop (or leaf) router to switch to the shortest path. The rate is
specified in kilobits per second.
Syntax
ip pimsm spt-threshold threshold
no ip pimsm spt-threshold
• threshold — Threshold rate. (Range: 0-2000 kilobits/sec)
Default Configuration
50 kilobits/sec is the default rate.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a threshold rate of 100 kilobits/sec.
console(config)#ip pimsm spt-threshold 100
ip pim-trapflags
Use the ip pim-trapflags command in Global Configuration mode to enable the PIM trap mode
for both Sparse Mode (SM) and Dense Mode (DM).
Syntax
ip pim-trapflags
no ip pim-trapflags
Default Configuration
Disabled is the default state.
Command Mode
Global Configuration mode.