Dell PowerConnect 8024 - Show Ip Ospf Virtual-Link

778 OSPF Commands
Example
The following example displays the OSPF stub table.
console(config)#show ip ospf stub table
AreaId TypeofService Metric Val Import SummaryLSA
------------- ------------- ---------- -----------------
0.0.0.1 Normal 1 Enable
show ip ospf virtual-link
Use the show ip ospf virtual-link command in Privileged EXEC mode to display the OSPF
Virtual Interface information for a specific area and neighbor.
Syntax
show ip ospf virtual-link area-id neighbor-id
• area-id — Identifies the OSPF area whose ranges are being displayed. (Range: IP address or
decimal from 0–4294967295)
•
neighbor-id — Identifies the neighbor’s router ID. (Range: Valid IP address)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF Virtual Interface information for area 10 and its
neighbor.
console#show ip ospf virtual-link 10 192.168.2.2
Area ID........................................ 10
Neighbor Router ID............................. 192.168.2.2