Dell PowerConnect 8024 Cli Reference Guide

302 IP Addressing Commands
ipv6 address
Use the ipv6 address command to set the IPv6 address of the management interface. Use the
"no" form of this command to reset the IPv6 address to the default.
Syntax
ipv6 address { prefix/prefix-length [eui64] | autoconfig | dhcp }
no ipv6 address
• prefix —Consists of the bits of the address to be configured.
•
prefix-length —Designates how many of the high-order contiguous bits of the address make
up the prefix.
•
eui64 —The optional eui-64 field designates that IPv6 processing on the interfaces is enabled
using an EUI-64 interface ID in the low order 64 bits of the address. If this option is used, the
value of prefix_length must be 64 bits.
•
autoconfig —Use this keyword to set the IPv6 address auto configuration mode.
•
dhcp —Use this keyword to obtain an IPv6 address via DHCP.
Default Configuration
There is no IPv6 address configured by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 address dhcp
console(config)#ipv6 address autoconfig
console(config)#ipv6 address 2003::6/64
console(config)#ipv6 address 2001::/64 eui64

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries