Dell PowerConnect 8024 - Ipv6 Ospf Priority; Ipv6 Ospf Retransmit-Interval

OSPFv3 Commands 805
Example
The following example changes the default OSPF network type to point-to-point.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf network point-to-point
ipv6 ospf priority
Use the ipv6 ospf priority command in Interface Configuration mode to set the OSPF priority
for the specified router interface.
Syntax
ipv6 ospf priority priority
no ipv6 ospf priority
• priority — OSPF priority for specified interface. (Range: 0-255. A value of 0 indicates that the
router is not eligible to become the designated router on this network)
Default Configuration
1, the highest router priority, is the default value.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF priority at 50 for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf priority 50
ipv6 ospf retransmit-interval
Use the ipv6 ospf retransmit-interval command in Interface Configuration mode to set the
OSPF retransmit interval for the specified interface.
Syntax
ipv6 ospf retransmit-interval seconds
no ipv6 ospf retransmit-interval