224 Dynamic ARP Inspection Commands
User Guidelines
There are no user guidelines for this command.
Example
console(config)#arp access-list tier1
clear counters ip arp inspection
Use the clear counters ip arp inspection command to reset the statistics for Dynamic ARP
Inspection on all VLANs.
Syntax
clear counters ip arp inspection
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
console#clear counters ip arp inspection
ip arp inspection filter
Use the ip arp inspection filter command to configure the ARP ACL to be used for a single
VLAN or a range of VLANs to filter invalid ARP packets. If the static keyword is given, packets
that do not match a permit statement are dropped without consulting the DHCP snooping
bindings. Use the “no” form of this command to unconfigure the ARP ACL.
Syntax
ip arp inspection filter
acl-name
vlan
vlan-range
[static]
no ip arp inspection filter
acl-name
vlan
vlan-range
[static]
•
acl-name
—The name of a valid ARP ACL. (Range: 1–31 characters)
•
vlan-range
—A valid VLAN range.
To Next Page
Loading...
