Dell PowerConnect 8024 - Enable Password

152 AAA Commands
no enable authentication
• default — Uses the default list created with the aaa authentication enable command.
•
list-name — Uses the indicated list created with the aaaa authentication enable command.
(Range: 1-12 characters)
Default Configuration
Uses the default set with the command aaa authentication enable.
Command Mode
Line Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example specifies the default authentication method when accessing a higher
privilege level console.
console(config)# line console
console(config-line)# enable authentication default
enable password
Use the enable password command in Global Configuration mode to set a local password to
control access to the privileged EXEC mode. To remove the password requirement, use the no
form of this command.
Syntax
enable password password [encrypted]
no enable password
• password — Password for this level (Range: 8- 64 characters).
•
encrypted — Encrypted password entered, copied from another switch configuration.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode