86 Command Groups
Loopback Interface
Multicast
Command Description Mode*
interface loopback Enters the Interface Loopback configuration mode. GC
show interface loopback Displays information about configured loopback interfaces. PE
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*
ip mcast boundary Adds an administrative scope multicast boundary. IC
ip mroute Creates a static multicast route for a source range. GC
ip multicast Sets the administrative mode of the IP multicast forwarder
in the router to active.
GC
ip multicast ttl-threshold Applies a
ttlvalue
to a routing interface. IC
ip pimsm Administratively enables PIM-SM multicast routing mode
on a particular router interface.
IC
ip pimsm bsr-border Prevents bootstrap router (BSR) messages from being sent
or received through an interface.
IC
ip pimsm bsr-candidate Configures the router to announce its candidacy as a
bootstrap router (BSR).
GC
ip pimsm dr-priority Sets the priority value for which a router is elected as the
designated router (DR).
IC
ip pimsm hello-interval Configures the PIM-SM Hello Interval for the specified
interface.
IC
ip pimsm join-prune-interval Configures the interface join/prune interval for the PIM-SM
router.
IC
ip pimsm register-threshold Configures the Register Threshold rate for the RP router to
switch to the shortest path.
GC
ip pimsm rp-address Statically configures the RP address for one or more
multicast groups.
GC
ip pimsm rp-candidate Configures the router to advertise itself as a PIM candidate
rendezvous point (RP) to the bootstrap router (BSR).
IC
ip pimsm spt-threshold Configures the Data Threshold rate for the lasthop router
to switch to the shortest path.
GC
ip pimsm ssm Defines the Source Specific Multicast (SSM) range of IP
multicast addresses.
GC
To Next Page
Loading...
